IsoPAQ-12L 2-channel isolator for 0(4)-20 mA current signals INOR
Ni v zalogi. Pošljite povpraševanje.
- Accuracy: 0.1 % FS
- Type: passive, 2-channel
- Installation depth: 104 mm
- input signal: 0(4) … 20 mA
- output signal: 0(4) … 20 mA
- test voltage: 1.5 kV, 50 Hz
- operating temperature: -20 °C … +70 °C
Description
The IsoPAQ-12L, INOR’s two-channel isolator for 0(4)-20 mA current signals, is used to isolate the current signal to prevent measurement errors due to different voltage potentials or ground loops in the instrument installation.
The IsoPAQ-12L isolator offers a low-cost alternative in combination with a space-saving (high-density) fixture that requires no power supply, reducing additional installation costs. High reliability ensures safe system operation and low maintenance costs.
Features of IsoPAQ-12L
- the entrance and exit are galvanically isolated: protection against erroneous measurements due to parasitic voltages or earth loops
- no power supply required: reduced wiring saves installation costs
- low voltage drop: input voltage drop of less than 2 V reduces the impact on the primary current loop
- high precision: negligible additional measurement errors in the loop
- DIN rail mounting: 12.5 mm housing in combination with very low self-heating allows space-saving (˝high-density˝) mounting
- plug-in screw connectors: simplifies installation and maintenance
ELPRO Lepenik offers technical support (TP-1, 30 min) and calibration.
Povpraševanje
You may also like…
For your victories, with our solutions. Call us:
Contact us.
Call us:
+386 (0)2 62 96 720
Email us:
[email protected]