QTC1-2 modular SHINKO controller

Description

The QTC1-2 modular SHINKO controller is a 2-channel control module that can be used to configure a multi-point control system via a PC or PLC. It can connect up to 16 instruments via BUS and control up to 32 measurement points. If the control module is used stand-alone, only one QTC1-2P SHINKO modular controller (with power/communication option) is required for connection to the power line.

All other or subsequent supply lines to the control module are connected to the BUS system via a connector. In this case, it makes sense to use the QTC1-20 modular controller (without power/communication options). Up to 16 control modules can be connected to it. Three types of QTC1-2 are available depending on the type of input/output. For more information, please see the enclosed instructions for use.

Using a communication extension module
QMC1
a maximum of 16 control modules can be connected to the QTC1-2 SHINKO modular controller. Up to 1024 measurement points can be measured and monitored with this connection. Communication starts with the transmission of commands from the host computer and ends with a response on the instrument.

 

Advantages of QTC1-2

• no software connection to the PLC required ( SIF function) for easier installation
• when connected to a PLC, allows measurement and control of up to 1024 measurement points
• useful as an analogue module, to optimise initial cost and wiring
• easy maintenance with fault prediction
• Maximum braking function for lower energy costs
• improved product quality (multi-zone connection, individual output selection)
• five control methods included for reduced analogue work
• 12 types of alarming
• improved maintenance (better visibility with different LED illuminations)
• MODBUS protocol
• type of mounting: DIN rail (possibility of mounting more modules)
• protection: fire protection (polycarbonate panel)
• Environmental requirements: compliance with the RoHS Directive
• Standards: EN61010-1, EN61326 (EMS)
• other functions

PLC connectivity without software (SIF function)

The SIF-SmartInterFace function (PLC communication function without the necessary software) allows direct connectivity to PLCs from different manufacturers.

Multi-zone connection (automatic balance control)

The modular controller allows the control of zones (areas) of a control target (group), by linking. This protects it from partial combustion and/or mechanical damage, while minimising adverse effects on product quality.

Software

Free software for the QTC1-2 modular controller is available at
link
.

 

Other designations: QTC1_2, QTC12, QTC1 2